You may experience a poor display performance or a low frame rate in your simulations if you have a large or complex cell. This can happen if you have a lot of objects or complex geometry in your station.Importing large 3D files can reduce the frame rate and slow down your simulations (see theprevioussection).

You can follow one or more of the following steps to improve the simulation speed and have a faster frame rate:

a)Ignore displaying small objects: SelectTools➔Options➔Displayand check the option “Don’t display objects smaller than” and set it to 2% or greater.

b)Simplify object geometry: SelectSimplify Object…in the same Display tab. This action does not alter the appearance of 3D objects. Selecting the root of the station (the first item) will apply the simplification to all objects in the station.

c)再保险move small objects: Select再保险move Small Objects…to remove small objects and triangles. This will delete the objects and triangles smaller than a given size.

一般——形象26

Tip: After you selectSimplify Object…select the root of the station to simplify all objects and robots in your cell.

Tip: Selectrender timeinTools ➔ Options ➔ Display to see the frame rate. The frame rate will be displayed at the bottom left of the screen.

Tip: SelectUse GPU arraysTools ➔ Options ➔ Display may provide faster results if you have a dedicated graphic card.

Note: If you are using VR you can also follow these additional performance tips described in the VR section.

Display Performance