08-28-2020, 02:19 PM
Hi Daryle,
在机器人面板中你有一个工具(model3), you are using with your robot.
This tool needs to be setup on the robot controller to make sure your coordinates match.
Alternatively, you can create a new tool (for example, Tool 0) and set the TCP values to XYZWPR = [0,0,0,0,0,0].
Albert
在机器人面板中你有一个工具(model3), you are using with your robot.
This tool needs to be setup on the robot controller to make sure your coordinates match.
Alternatively, you can create a new tool (for example, Tool 0) and set the TCP values to XYZWPR = [0,0,0,0,0,0].
Albert