10-15-2022, 02:23 AM
Hi,
I am able to control my kuka robot in the RoboDK GUI, but I cant figure out how to specify the port over the API. I am trying to use therobot.Connectfunction, which takes an IP address but not a port.
I followed the advice in the link below to set a different rather than 7000 due to conflict with nginx.
//m.sinclairbody.com/doc/en/Robots-KUKA.html#DriverKUKA
Thnaks!
I am able to control my kuka robot in the RoboDK GUI, but I cant figure out how to specify the port over the API. I am trying to use therobot.Connectfunction, which takes an IP address but not a port.
I followed the advice in the link below to set a different rather than 7000 due to conflict with nginx.
//m.sinclairbody.com/doc/en/Robots-KUKA.html#DriverKUKA
Thnaks!