RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Drifting Issue with Assembly
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Drifting Issue with Assembly

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Drifting Issue with Assembly
eugmoses Offline
Junior Member
*
Posts: 5
Threads: 2
Joined: Aug 2022
Reputation: 0
#3
08-19-2022, 04:46 PM (This post was last modified: 08-19-2022, 04:50 PM byeugmoses.)
(08-19-2022, 11:50 AM)Sam Wrote:Hi Eugene,

Is your fixture mounted on a conveyor? Or any mechanism with a lateral axis?

Hello Sam,

Thank you for the support. I am not using fixture and placing the roller on top of the base frame which is not on any support. Attached below is the picture of the base frame and roller assembly which is positioned in free space above floor.

Regards,

Eugene Moses R


Attached Files Thumbnail(s)

Find
Reply


Messages In This Thread
Drifting Issue with Assembly - byeugmoses- 08-19-2022, 06:11 AM
RE: Drifting Issue with Assembly - bySam- 08-19-2022, 11:50 AM
RE: Drifting Issue with Assembly - byeugmoses- 08-19-2022, 04:46 PM
RE: Drifting Issue with Assembly - byAlbert- 08-20-2022, 08:38 AM
RE: Drifting Issue with Assembly - byeugmoses- 08-20-2022, 09:25 AM
RE: Drifting Issue with Assembly - bySam- 09-28-2022, 10:49 AM



Users browsing this thread:
1 Guest(s)