Hi Albert,
thanks for the suggestion, but messing with KUKA driver may be a little bit beyond my capabilities. I think I can (ab)use the customised section ofRoboDKsyncfor my purposes, just as you proposed in the other thread:
//m.sinclairbody.com/forum/Thread-Pyton-Sp...ng-project
[url=//m.sinclairbody.com/forum/Thread-Pyton-Specific-post-processor-and-run-mode-for-machining-project][/url]
For offline programming it should be no problem, just as you say. I have not tried that yet, but looking at the post processor that should work out just fine.
thanks for the suggestion, but messing with KUKA driver may be a little bit beyond my capabilities. I think I can (ab)use the customised section ofRoboDKsyncfor my purposes, just as you proposed in the other thread:
//m.sinclairbody.com/forum/Thread-Pyton-Sp...ng-project
[url=//m.sinclairbody.com/forum/Thread-Pyton-Specific-post-processor-and-run-mode-for-machining-project][/url]
For offline programming it should be no problem, just as you say. I have not tried that yet, but looking at the post processor that should work out just fine.