Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Programs produced by RoboDK for 3D print on KUKA KR6 (KRC4) cannot be selected

#2
Hi Andy,

Can you send me the screen shot here? I would prefer keeping the whole conversation here so that if other users experiment the same situation, they will be able to solve it by following this thread.

I'm sure you can find a way to reduce the size of the pictures.
You can try to simply save them as .jpg instead of .png, it should help a lot.

Have a good day.
Jeremy


Messages In This Thread
RE: Programs produced by RoboDK for 3D print on KUKA KR6 (KRC4) cannot be selected - byJeremy- 03-29-2019, 11:32 PM



Users browsing this thread:
1 Guest(s)