RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Move joints doesn't work
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Move joints doesn't work

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Move joints doesn't work
houda Offline
Junior Member
*
Posts: 4
Threads: 2
Joined: Oct 2021
Reputation: 0
#1
Question 10-27-2021, 12:18 AM (This post was last modified: 10-27-2021, 01:23 PM byAlbert.)
''Move joint'' don't work.

I try to connect Robodk to a Kuka robot, ''Get position'' work well but ''move joints'' stay ''working.. (in yellow)''. see picture attached.
我不知道是否有关系between that and the compilationerrorsdisplayed on robot when is started.

Robot: Kuka KR 6 R700 sixx
Robodk version:v3.5.4 (64 bit)


Attached Files Thumbnail(s)

Find
Reply


Messages In This Thread
Move joints doesn't work - byhouda- 10-27-2021, 12:18 AM
RE: Move joints doesn't work - byAlbert- 10-27-2021, 01:25 PM
RE: Move joints doesn't work - byhouda- 10-28-2021, 01:43 PM
RE: Move joints doesn't work - byJeremy- 10-28-2021, 03:13 PM
RE: Move joints doesn't work - byhouda- 10-28-2021, 05:17 PM



Users browsing this thread:
1 Guest(s)