09-02-2021, 03:17 AM
(This post was last modified: 09-02-2021, 03:18 AM byTOMMY.CHIEN.)
Dear sir,
I'm trying to use RoboDK to connect TM robot with my laptop and control the robot directly in real time.
I follow the step below:
1. SelectConnect➔Connect robot
2. Enter the robot IP
3. Enter the port 5890
4. Right click your program
5. SelectGenerate robot program F6.
But I still can connect the robot even I turn off all the firewalls.
I also open the cmd to ping the robot by my laptop, and the connection is no problem.
am I lost something?
The TMflow version I use is 1.82.5100.
Thanks.
I'm trying to use RoboDK to connect TM robot with my laptop and control the robot directly in real time.
I follow the step below:
1. SelectConnect➔Connect robot
2. Enter the robot IP
3. Enter the port 5890
4. Right click your program
5. SelectGenerate robot program F6.
But I still can connect the robot even I turn off all the firewalls.
I also open the cmd to ping the robot by my laptop, and the connection is no problem.
am I lost something?
The TMflow version I use is 1.82.5100.
Thanks.