02-22-2019, 03:44 AM
嗨,约翰,
It's certainly easier to generate entry and exit profiles from a CAM software. I didn't imply that you should use Alphacam, I was just pointing toward part of the information you needed, sorry if I was unclear.
I can give you a little trick that is a bit hidden for the moment (I'll make a video on that subject in a near future.), you can use a sketch in SolidWorks to create your path with the plugin.
I only tried with a 2D sketch, but I'm pretty sure that you could do that with a 3D sketch.
I think that I would use that approach to create nice 3D entry and exit profiles.
Let me know if it works.
And to answer your question, I don't see anything at the moment that could prevent you from using a remote TCP.
Jeremy
It's certainly easier to generate entry and exit profiles from a CAM software. I didn't imply that you should use Alphacam, I was just pointing toward part of the information you needed, sorry if I was unclear.
I can give you a little trick that is a bit hidden for the moment (I'll make a video on that subject in a near future.), you can use a sketch in SolidWorks to create your path with the plugin.
I only tried with a 2D sketch, but I'm pretty sure that you could do that with a 3D sketch.
I think that I would use that approach to create nice 3D entry and exit profiles.
Let me know if it works.
And to answer your question, I don't see anything at the moment that could prevent you from using a remote TCP.
Jeremy