RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Extruder not synchronized with of robot mouvement
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Extruder not synchronized with of robot mouvement

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Extruder not synchronized with of robot mouvement
blanc_p Offline
Junior Member
*
Posts: 3
Threads: 1
Joined: Jul 2021
Reputation: 0
#1
07-01-2021,为我 (This post was last modified: 07-01-2021, 08:47 AM byblanc_p.)
Hello,
I want to drive a stepper motor by sending steps through the I/O outputs. I can do it but my problem is that my extruder is not synchronized with the movement of my robot... My extruder works at first, then my movement is done...
Do you have an idea to synchronize them?
An exemple of my code in attachments.

Thanks

Paul


Attached Files Thumbnail(s)

Find
Reply


Messages In This Thread
Extruder not synchronized with of robot mouvement - byblanc_p- 07-01-2021, 08:45 AM



Users browsing this thread:
1 Guest(s)