06-15-2021, 10:19 AM
Where do you receive the error.
In RoboDK or on the Teach Pendant?
I see why this would happen... If it wasn't a remote TCP situation, it would work just fine.
I have a few solutions for you.
1 - You modify MasterCAM parameters for it to only generate MoveLs, very small MoveLs for the rounded section.
2 -在RoboDK,“工具”- >“选项”- >“程序”- >“Maxarc size (mm)"-> set to 1 or 2 mm.
Jeremy
In RoboDK or on the Teach Pendant?
I see why this would happen... If it wasn't a remote TCP situation, it would work just fine.
I have a few solutions for you.
1 - You modify MasterCAM parameters for it to only generate MoveLs, very small MoveLs for the rounded section.
2 -在RoboDK,“工具”- >“选项”- >“程序”- >“Maxarc size (mm)"-> set to 1 or 2 mm.
Jeremy
Find useful information about RoboDK and its features by visiting ourOnline Documentationand by watching tutorials on ourYoutube Channel.