RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Problem whit mastercam and robodk
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Problem whit mastercam and robodk

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Problem whit mastercam and robodk
Jeremy Offline
Moderator
*****
Posts: 1,832
Threads: 2
Joined: Oct 2018
Reputation: 70
#9
06-07-2021, 03:04 PM
你有刀位点(NCI)转移from MasterCAM to RoboDK?
It should be in your Temp file

Jeremy
Find useful information about RoboDK and its features by visiting ourOnline Documentationand by watching tutorials on ourYoutube Channel.


Find
Reply


Messages In This Thread
Problem whit mastercam and robodk - byBruno- 01-02-2021, 04:42 PM
RE: Problem whit mastercam and robodk - byJeremy- 01-03-2021, 05:51 AM
RE: Problem whit mastercam and robodk - byBruno- 01-05-2021, 10:24 PM
RE: Problem whit mastercam and robodk - byJeremy- 01-07-2021, 03:44 PM
RE: Problem whit mastercam and robodk - byAlbert- 01-11-2021, 06:15 PM
RE: Problem whit mastercam and robodk - byJeremy- 06-03-2021, 08:19 AM
RE: Problem whit mastercam and robodk - byJeremy- 06-07-2021, 03:04 PM
RE: Problem whit mastercam and robodk - byJeremy- 06-07-2021, 08:17 PM



Users browsing this thread:
1 Guest(s)