Hi,
"No connection made because target machine actively refused it "
This means what it means, the "issue" is on TM Flow side I believe.
Did you properly activate the Modbus and Ethernet communication on your controller?
Are you connected to the Ethernet port that does accept Modbus communication? (There is 3 RJ-45 port on the controller, use the one "alone".)
你听节点程序之前运行公关吗essing "Get position"?
Did you try just the "Commands" from the connection interface?
If you change the port or if you activate Modbus or Ethernet, I'm pretty sure you need to restart your controller for it to take effect.
Jeremy
"No connection made because target machine actively refused it "
This means what it means, the "issue" is on TM Flow side I believe.
Did you properly activate the Modbus and Ethernet communication on your controller?
Are you connected to the Ethernet port that does accept Modbus communication? (There is 3 RJ-45 port on the controller, use the one "alone".)
你听节点程序之前运行公关吗essing "Get position"?
Did you try just the "Commands" from the connection interface?
If you change the port or if you activate Modbus or Ethernet, I'm pretty sure you need to restart your controller for it to take effect.
Jeremy
Find useful information about RoboDK and its features by visiting ourOnline Documentationand by watching tutorials on ourYoutube Channel.