05-24-2021, 10:13 AM
Hi all,
We are looking to implement an extrusion head to our IRB6600 with S4C Plus controller. We have room for an extra servo drive but also have extra room on the input/output card so we can control the servo motor either way theoretically. I am wondering though, what is the better implementation with Robodk servo drive or i/o?
Thanks
We are looking to implement an extrusion head to our IRB6600 with S4C Plus controller. We have room for an extra servo drive but also have extra room on the input/output card so we can control the servo motor either way theoretically. I am wondering though, what is the better implementation with Robodk servo drive or i/o?
Thanks