RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Importing G code into RoboDK
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Importing G code into RoboDK

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Importing G code into RoboDK
Jeremy Offline
Moderator
*****
Posts: 1,832
Threads: 2
Joined: Oct 2018
Reputation: 72
#4
04-26-2021, 11:05 AM
It's because RoboDK does not recognize a .txt file as a potential GCode file.

For RDK, .txt files are either "points" or "curves" for the Point Follow Project and the Curve Follow Project.

If you want RoboDK to automatically recognize your file, rename it .gcode or .nc, it should then work.

Jeremy
Find useful information about RoboDK and its features by visiting ourOnline Documentationand by watching tutorials on ourYoutube Channel.


Find
Reply


Messages In This Thread
Importing G code into RoboDK - byPetrus- 04-22-2021, 12:29 PM
RE: Importing G code into RoboDK - bycolinb83- 04-22-2021, 02:58 PM
RE: Importing G code into RoboDK - byPetrus- 04-23-2021, 01:44 PM
RE: Importing G code into RoboDK - byJeremy- 04-26-2021, 11:05 AM



Users browsing this thread:
1 Guest(s)