Hi,
Thanks for your reply, I have done this with Curve follow project and I solved this issue later as you suggested.
Okay, I have another question regarding to this. The edge I have selected is made by modeling a pipe through that hole inside the bigger pipe and then setting an offset to that.
So is there a better way to maintain the tool angle like this?
I read somewhere that setting "Allow tool Z rotation" to zero would help but it didn`t in this situation.
Thanks for your reply, I have done this with Curve follow project and I solved this issue later as you suggested.
Okay, I have another question regarding to this. The edge I have selected is made by modeling a pipe through that hole inside the bigger pipe and then setting an offset to that.
So is there a better way to maintain the tool angle like this?
I read somewhere that setting "Allow tool Z rotation" to zero would help but it didn`t in this situation.