RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Offset to path
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Offset to path

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Offset to path
ophakala Offline
Member
**
Posts: 22
Threads: 7
Joined: Mar 2021
Reputation: 0
#1
04-20-2021, 07:33 AM (This post was last modified: 04-20-2021, 07:43 AM byophakala.)
Hey,

how can I set a constant offset to curved edge ? I have done a milling program but now the tool center follows the edge as shown in the picture and I would like to move it 5mm inward. Path to tool offset doesn`t work in this situation because the path isn`t straight. Thanks in advance!

Find
Reply


Messages In This Thread
Offset to path - byophakala- 04-20-2021, 07:33有空
RE: Offset to path - byOlivier- 04-20-2021, 05:46 PM
RE: Offset to path - byophakala- 04-22-2021, 06:22 AM
RE: Offset to path - byOlivier- 04-22-2021, 05:54 PM



Users browsing this thread:
1 Guest(s)