We have been trying to get RoboDK connected to our KUKA KR6 robot. We have followed the documented installation procedure closely, but have the following problems :
KUKAVARPROXY.EXE when launched from the desktop produces a pop up window , but does not seem to run or make any noticeable progress on this. Is this normal ? does it take quite a while ??
We were told to run the $config file manually. How do you do this , we have tried every option we can think of ?
When trying to make aconnection with the robot, we have checked the robot IP from the Smart Pad display. However when we try to Ping the address it fails.
任何帮助将感激地received as it is getting quite frustrating now !
Thanks
Andy
KUKAVARPROXY.EXE when launched from the desktop produces a pop up window , but does not seem to run or make any noticeable progress on this. Is this normal ? does it take quite a while ??
We were told to run the $config file manually. How do you do this , we have tried every option we can think of ?
When trying to make aconnection with the robot, we have checked the robot IP from the Smart Pad display. However when we try to Ping the address it fails.
任何帮助将感激地received as it is getting quite frustrating now !
Thanks
Andy