02-24-2021, 03:01 PM
嗨Deisengard,
This is not a bug.
First, the move to Z = 0 is part of the G-Code generated by Simplify3D.
You can see that from this print screen.
Second, before post-processing, RoboDK will filter points and remove any point exactly at the same position as another. Therefore, the "approach 100 mm normal" is replaced by the PTP to that exact same position but using the joint values.
Have a great day.
Jeremy
This is not a bug.
First, the move to Z = 0 is part of the G-Code generated by Simplify3D.
You can see that from this print screen.
Second, before post-processing, RoboDK will filter points and remove any point exactly at the same position as another. Therefore, the "approach 100 mm normal" is replaced by the PTP to that exact same position but using the joint values.
Have a great day.
Jeremy
Find useful information about RoboDK and its features by visiting ourOnline Documentationand by watching tutorials on ourYoutube Channel.