RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Problem whit mastercam and robodk
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Problem whit mastercam and robodk

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Problem whit mastercam and robodk
Jeremy Offline
主持人
*****
Posts: 1,832
Threads: 2
Joined: Oct 2018
Reputation: 70
#4
01-07-2021, 03:44 PM
Hi Bruno,

I didn't use our MasterCAM plugin in a while as I don't have a valid license here, but if I remember correctly, you need to set the tool length manually after the cutters were created.

Maybe @Albertcan confirm?

Jeremy
Find useful information about RoboDK and its features by visiting ourOnline Documentationand by watching tutorials on ourYoutube Channel.


Find
Reply


Messages In This Thread
Problem whit mastercam and robodk - byBruno- 01-02-2021, 04:42 PM
RE: Problem whit mastercam and robodk - byJeremy- 01-03-2021, 05:51 AM
RE: Problem whit mastercam and robodk - byBruno- 01-05-2021, 10:24 PM
RE: Problem whit mastercam and robodk - byJeremy- 01-07-2021, 03:44 PM
RE: Problem whit mastercam and robodk - byAlbert- 01-11-2021, 06:15 PM
RE: Problem whit mastercam and robodk - byJeremy- 06-03-2021, 08:19 AM
RE: Problem whit mastercam and robodk - byJeremy- 06-07-2021, 03:04 PM
RE: Problem whit mastercam and robodk - byJeremy- 06-07-2021, 08:17 PM



Users browsing this thread:
1 Guest(s)