01-06-2021, 01:40 PM
**Update**
I spend some more into the generated code and noticed 2 more things that might be of use (one of which I basically forgot to mention earlier)
1. I'm loading the files in the Aubo as a project, but the only we I can run them is if I receive them as a Procedure. Other wise running them results in a system crash.
(If I load them as procedure running also results in a system crash).
2. Upon closer inspection it seems the Aubo doesn't load the speeds at m/s but rather as a percentage based on some internal speeds. So 50 mm/s in RoboDK translates to 50% of 2000mm/s in the Aubo software.
I spend some more into the generated code and noticed 2 more things that might be of use (one of which I basically forgot to mention earlier)
1. I'm loading the files in the Aubo as a project, but the only we I can run them is if I receive them as a Procedure. Other wise running them results in a system crash.
(If I load them as procedure running also results in a system crash).
2. Upon closer inspection it seems the Aubo doesn't load the speeds at m/s but rather as a percentage based on some internal speeds. So 50 mm/s in RoboDK translates to 50% of 2000mm/s in the Aubo software.