12-17-2020, 08:52 PM
I don't get it. I don't see a difference.
- I change the "Rounding" parameter form 0,xxx to 100 mm - I update the path. No noticeable difference. I generate robot program. Its 750 rows.
- I change the minimum step size from 0,005 to 5mm - A 1000x increase... No noticeable difference.
我关闭程序,打开程序。
I choose new NC files... I choose the old NC file again. No visual difference in the program. No difference in the generated Kuka KRL program file.
Are the changes not taking effect?
I was expecting such an extreme change in these parameters to have an extreme effect and I can start dialing it down... but I see no change. What am I doing wrong?
- I change the "Rounding" parameter form 0,xxx to 100 mm - I update the path. No noticeable difference. I generate robot program. Its 750 rows.
- I change the minimum step size from 0,005 to 5mm - A 1000x increase... No noticeable difference.
我关闭程序,打开程序。
I choose new NC files... I choose the old NC file again. No visual difference in the program. No difference in the generated Kuka KRL program file.
Are the changes not taking effect?
I was expecting such an extreme change in these parameters to have an extreme effect and I can start dialing it down... but I see no change. What am I doing wrong?