12-01-2020, 09:04 PM
Hello!
I have a couple of questions concerning visualization.
1. Is it possible to visualize spraying in exported simulation or is it only for simulations inside RoboDK? At least the visualization didn't get exported as I tried with html- file.
2. I tried visualized spraying for part made with SolidWorks. STEP-files, part- files, importing with RoboDK plug-in etc.. But I had a problem that spraying didn't show in all surfaces. My part is made of multiple extrusions(well just 4) so when I cut the part to smaller parts (only 1 extrusion per part) the spraying worked fine. Is there some obvious reason for this?
All this is based on RoboDK:s Example-01.a-Robot Painting - Universal Robots
Thank you
I have a couple of questions concerning visualization.
1. Is it possible to visualize spraying in exported simulation or is it only for simulations inside RoboDK? At least the visualization didn't get exported as I tried with html- file.
2. I tried visualized spraying for part made with SolidWorks. STEP-files, part- files, importing with RoboDK plug-in etc.. But I had a problem that spraying didn't show in all surfaces. My part is made of multiple extrusions(well just 4) so when I cut the part to smaller parts (only 1 extrusion per part) the spraying worked fine. Is there some obvious reason for this?
All this is based on RoboDK:s Example-01.a-Robot Painting - Universal Robots
Thank you