11-19-2020, 11:03 AM
Hi Jeremy,
As you said, FANUC does not use mm for Rounding, it uses %.
while, as shown in the following figure, if I set Set Rounding in robodk to 20, CNT 20 would appear in the LS/TP file generated by robodk.
Is the actual value of the CNT 20% of the distance between P1 and P3 ?
Loaferhit
As you said, FANUC does not use mm for Rounding, it uses %.
while, as shown in the following figure, if I set Set Rounding in robodk to 20, CNT 20 would appear in the LS/TP file generated by robodk.
Is the actual value of the CNT 20% of the distance between P1 and P3 ?
Loaferhit