11-02-2020, 09:26 PM
Hi IridiumCNC,
Yes it's possible.
In "Tools"->"Options"->"Program" you can find a "Minimum step size (mm)".
You can change that setting according to your needs.
请注意,这只会影响到通用电气nerated program, you won't see any difference in the simulation environment.
Also, for fluid motion, you need to make sure to activate the "Rounding".
in your Machining project, "Program Events" and increase the value of "Rounding".
You can surely also set Fusion 360 in a way that its tolerance is higher, therefore producing less point in tight corners.
Jeremy
Yes it's possible.
In "Tools"->"Options"->"Program" you can find a "Minimum step size (mm)".
You can change that setting according to your needs.
请注意,这只会影响到通用电气nerated program, you won't see any difference in the simulation environment.
Also, for fluid motion, you need to make sure to activate the "Rounding".
in your Machining project, "Program Events" and increase the value of "Rounding".
You can surely also set Fusion 360 in a way that its tolerance is higher, therefore producing less point in tight corners.
Jeremy
Find useful information about RoboDK and its features by visiting ourOnline Documentationand by watching tutorials on ourYoutube Channel.