Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Universal Robot Programs

#1
Hello,

I created a program in Robodk and tested it by hitting the "Run on Robot" and everything ran fine. but when i try to run it from polyscope the positions are not where they should be. could it be from the installation file thats loaded in polyscope? or would it be caused from a tcp issue? thanks


Messages In This Thread
Universal Robot Programs - byjacob.stewart- 10-19-2020, 11:33 AM
RE: Universal Robot Programs - byJeremy- 10-19-2020, 03:09 PM



Users browsing this thread:
1 Guest(s)