抢劫oDK Forum> 抢劫oDK (EN)> General questions about RoboDK> Curves Tool Orientation
抢劫oDK Forum> 抢劫oDK (EN)> General questions about RoboDK> Curves Tool Orientation

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Curves Tool Orientation
mmccrea_BAT Offline
Junior Member
*
Posts: 4
Threads: 4
Joined: Jul 2020
Reputation: 0
#1
10-06-2020, 11:27 AM
When I import curves from Solidworks the tool is always 45degrees to the curve as shown below, I would like the tool to be 90 degrees to the curve, I would like the grey arrows to straight up. How do I change this?

Thank you
mark
Find
Reply


Messages In This Thread
Curves Tool Orientation - bymmccrea_BAT- 10-06-2020, 11:27 AM
RE: Curves Tool Orientation - byOlivier- 10-06-2020, 02:02 PM



Users browsing this thread:
1 Guest(s)