07-15-2020, 03:31 PM
Can you link the g-code you used?
What extension is the file?
The path in RoboDK should match the path in NX.
If it's not the case, something must be wrong. It can be the format of the NC file. If you used a Post-processor specifically created for a specific CNC, the NC file may have some specificity.
Do you have a post-processor that creates .APT files?
Jeremy
What extension is the file?
The path in RoboDK should match the path in NX.
If it's not the case, something must be wrong. It can be the format of the NC file. If you used a Post-processor specifically created for a specific CNC, the NC file may have some specificity.
Do you have a post-processor that creates .APT files?
Jeremy