RoboDK Forum> RoboDK (EN)> General questions about RoboDK> 目标是不可到达的
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> 目标是不可到达的

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
目标是不可到达的
Kari Offline
Member
**
Posts: 13
Threads: 6
Joined: Feb 2020
Reputation: 0
#1
05-02-2020, 11:57 AM (This post was last modified: 05-02-2020, 11:58 AM byKari.)
Hi!

Why am I getting an error message: "Target is not reachable", when I run the program, but when I speed up the program I get no error messages and the program works fine? It seems that the program works fine when it is speeded up, but otherwise I get error messages .. Trying to adjust the target, but although it may work once, the error message reappears later .. Is this a bug? How can I fix this?

Best regards Kari
Find
Reply


Messages In This Thread
目标是不可到达的 - byKari- 05-02-2020, 11:57 AM
RE: Target is not reachable - byAlbert- 05-04-2020, 01:51 PM
RE: Target is not reachable - byJBA- 05-07-2020, 05:22 AM
RE: Target is not reachable - byJeremy- 05-13-2020, 06:45 PM



Users browsing this thread:
1 Guest(s)