[mohammedaminebel]

实际上,我将使机器人的第一步project and i don't want to make the wrong one, i'm searching for which controller board is easy to be connected with Robodk (which is support by an existing post processor in Robodk), for my knowledge the most known ones and easiest to use are Arduino or Raspberry pi, but on the other hand, i didn't find how to link them with Robodk, so i'm afraid to begin my project and at the end i will be blocked because of this issue.

so, as a beginner, which language i shoold use in my controller (arduino or raspberry) to be supported by an existing post processor in Robodk ? or which controller bord (that i could buy) is supported by an existing post processor in Robodk ?