RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Drill cycle issue
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Drill cycle issue

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Drill cycle issue
Piotr K Offline
Member
**
Posts: 31
Threads: 10
Joined: Nov 2019
Reputation: 2
#1
11-21-2019, 08:31 AM
Hi,

I have an issue with drill cycle. I have generated a G-code as APT and when I transfer it to "Machining project" in RoboDK i get an error message "Invaild cycle parameters". My question is: what parameters are needed to work properlty?


I sent a G-code and screenshot with error.

Best regards,
Piotr


Attached Files Thumbnail(s)


.apt iMachining_2D_2.APT(Size: 2.68 MB / Downloads: 445)
Find
Reply


Messages In This Thread
Drill cycle issue - byPiotr K- 11-21-2019, 08:31 AM
RE: Drill cycle issue - byAlbert- 11-25-2019, 05:39点



Users browsing this thread:
1 Guest(s)