11-18-2019, 06:27 PM
Hello all,
I am revisiting this thread to avoid creating a new one.
Regarding the Program Event that sets the Extruder Feed, I was wondering if there was a way to include more than 3 decimals. Curently, I am slicing my parts with Simplify3D and importing the Gcode into RoboDK. Now, with S3D, all of the Extrusion values contain 4 decimals and I would like to keep those decimals without RoboDK to round these values.
Do you guys know if there is a way to do that?
我非常感谢你一口port.
JF
I am revisiting this thread to avoid creating a new one.
Regarding the Program Event that sets the Extruder Feed, I was wondering if there was a way to include more than 3 decimals. Curently, I am slicing my parts with Simplify3D and importing the Gcode into RoboDK. Now, with S3D, all of the Extrusion values contain 4 decimals and I would like to keep those decimals without RoboDK to round these values.
Do you guys know if there is a way to do that?
我非常感谢你一口port.
JF