11-13-2019, 12:29 PM
Hello,
I had the same problem with ur5e.
I didn't know what was meant by ''operational mode''. I mean it is obvious that your robot should be turned on and you should start motors on.
In my case, the connection starts working when I chose remote control on the robot controller. I also let the port in RoboDK environment the same as it is automatically selected in my case it was Robot port: 2000.
Best regards,
Simon
I had the same problem with ur5e.
I didn't know what was meant by ''operational mode''. I mean it is obvious that your robot should be turned on and you should start motors on.
In my case, the connection starts working when I chose remote control on the robot controller. I also let the port in RoboDK environment the same as it is automatically selected in my case it was Robot port: 2000.
Best regards,
Simon