11-04-2019, 12:03 PM
Are you running in manual mode or automatic mode?
You can reduce the density of points in the following menu:
Tools-Options-Program-Minimum一步大小(毫米)
The default value is 0.005 mm but you can increase it to 2 mm to see if it goes faster.
I don't think this is the reason though. Your points are not that close to each other. You may have a configuration variable limiting the robot speed.
You can reduce the density of points in the following menu:
Tools-Options-Program-Minimum一步大小(毫米)
The default value is 0.005 mm but you can increase it to 2 mm to see if it goes faster.
I don't think this is the reason though. Your points are not that close to each other. You may have a configuration variable limiting the robot speed.