RoboDK Forum> RoboDK (EN)> General questions about RoboDK> end of path tool orientation is not half way between 2 surface
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> end of path tool orientation is not half way between 2 surface

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
end of path tool orientation is not half way between 2 surface
HKU Offline
Junior Member
*
Posts: 4
Threads: 2
Joined: Oct 2019
Reputation: 0
#1
10-13-2019, 02:47 PM (This post was last modified: 10-13-2019, 03:06 PM byHKU.)
made something similar to the sample video for sw plug-in auto setup. the object and path transfer to robodk without problem. however, the last point of the curve, the tool orientation does not fall between the two picked surfaces. as i understand, it is not possible to change orientation for just one point one the curve.



what could have went wrong?


Attached Files
.rdk ABB1600-TEST.rdk(Size: 118.58 KB / Downloads: 333)
Find
Reply


Messages In This Thread
end of path tool orientation is not half way between 2 surface - byHKU- 10-13-2019, 02:47 PM



Users browsing this thread:
1 Guest(s)