08-26-2019, 10:42 AM
Are you using a recent version of RoboDK?
Did you set the controller variable to 1 as specified here?
//m.sinclairbody.com/forum/Thread-Connect-...585#pid585
Do you get any errors or warnings on the robot?
On a command line window (Windows key + Run, then, type cmd), type:
netstat
You should see your computer's IP listed with the port (the port you specified in the connection parameters)
Did you set the controller variable to 1 as specified here?
//m.sinclairbody.com/forum/Thread-Connect-...585#pid585
Do you get any errors or warnings on the robot?
On a command line window (Windows key + Run, then, type cmd), type:
netstat
You should see your computer's IP listed with the port (the port you specified in the connection parameters)