07-10-2019, 03:30 PM
Hello Albert,
Thank you for you reply. I am generating my G-code using Simplify3D. I have a lot of flexibility for outputing my code, but I notice that RoboDK is using Slic3r. Do you see any advantages of using Slic3r via RoboDK instead of slicing in S3D and then importing the toolpath?
Also, I don't have the tooltips that you are refering to (see attached screenshot). Is it possible that I have an older version of RoboDK?
Regards,
JF
Thank you for you reply. I am generating my G-code using Simplify3D. I have a lot of flexibility for outputing my code, but I notice that RoboDK is using Slic3r. Do you see any advantages of using Slic3r via RoboDK instead of slicing in S3D and then importing the toolpath?
Also, I don't have the tooltips that you are refering to (see attached screenshot). Is it possible that I have an older version of RoboDK?
Regards,
JF