RoboDK Forum> RoboDK (EN)> General questions about RoboDK> G-code unit conversion
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> G-code unit conversion

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
G-code unit conversion
Daniel.Piche Offline
Junior Member
*
Posts: 5
Threads: 2
Joined: Jul 2019
Reputation: 0
#1
07-10-2019,下午03:20
I'm doing a machining project and the g-code generation is in inches. Is there a parameter to convert the g-code in mm?
Find
Reply


Messages In This Thread
G-code unit conversion - byDaniel.Piche- 07-10-2019, 03:20 PM
RE: G-code unit conversion - byJeremy- 07-10-2019, 03:51 PM
RE: G-code unit conversion - byDaniel.Piche- 07-15-2019, 01:42 PM



Users browsing this thread:
1 Guest(s)