RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Display of path data and verification of the grinding process during grinding
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Display of path data and verification of the grinding process during grinding

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Display of path data and verification of the grinding process during grinding
owen8410 Offline
Junior Member
*
Posts: 6
Threads: 3
Joined: Jun 2019
Reputation: 0
#1
07-05-2019, 05:23点

I have a project to grind in Robodk. How can I display the path data and verification of the grinding process during the grinding process?Could you help me see my project?

1. Is it possible to verify that the knife has been ground to the surface during grinding?
2. Can the tool posture fix the arm posture during the grinding process?
3. When the surface and line are merged into Robodk, they will not be on the same surface.
At present, I am manually moving the line segment to the surface. Is there any other way to merge the surface and line into the back or fixed position?I don't know how to do it now.


Attached Files
.rdk 去毛邊模擬.rdk(Size: 5.6 MB / Downloads: 365)
Find
Reply


Messages In This Thread
Display of path data and verification of the grinding process during grinding - byowen8410- 07-05-2019, 05:23 PM



Users browsing this thread:
1 Guest(s)