RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Corner turn in machining toolpath
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Corner turn in machining toolpath

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Corner turn in machining toolpath
thanh019 Offline
Member
**
Posts: 14
Threads: 6
Joined: Mar 2023
Reputation: 0
#3
05-12-2023, 03:13 AM
(05-11-2023, 06:56 PM)Sergei Wrote:You can try using the'Tool orientation follows path'option for the'Selection algorithm'parameter.


Hello,
Thank you very much for your suggestion. However, now the situation meets the problem shown in the picture, as the tool changes its orientation already before the corner. Can you please show me what parameters or methods I can modify to fix this? Thank you once again.
Find
Reply


Messages In This Thread
Corner turn in machining toolpath - bythanh019- 05-11-2023, 03:41 AM
RE:角落里你rn in machining toolpath - bythanh019- 05-12-2023, 03:13 AM
RE:角落里你rn in machining toolpath - bythanh019- 05-22-2023, 08:29有空



Users browsing this thread:
1 Guest(s)