03-20-2023, 12:55 PM
(This post was last modified: 03-20-2023, 02:21 PM byrgl1396.Edit Reason: Forgot attachment
)
Hello,
I used the SW add-in to generate a path for my UR3 to follow, however I want the nozzle tip to remain normal to the surface being deposited on. How would I make this possible? Please see the attached photo.
I am able to have the nozzle remain normal to the surface if I select a curve on the edge of the part (happens automatically), but I need to have specific patterns that will not work by just selecting a single edge.
Any help is greatly appreciated!
Thank you
I used the SW add-in to generate a path for my UR3 to follow, however I want the nozzle tip to remain normal to the surface being deposited on. How would I make this possible? Please see the attached photo.
I am able to have the nozzle remain normal to the surface if I select a curve on the edge of the part (happens automatically), but I need to have specific patterns that will not work by just selecting a single edge.
Any help is greatly appreciated!
Thank you