09-22-2022, 11:19 PM
Thanks for following up!
我已经能够get TCP/IP communication established between the Epson and a host PC. This was using the Epson RC control software to configure the TCP/IP communication on the robot controller using USB interface. I then tested communications with ethernet using an offline host PC with the controller configuration which were successful.
When I pass the same parameters to the Epson using the connect online functionality in RoboDK, it tells me that the machine is actively refusing the refusing the connection. [win 10061 error] (I have tested after completely disconnecting from the robot in the Epson RC software first)
I'm not sure which argument could be specified to the robot incorrectly. I have attached a screenshot for your reference. The robot also wasn't in any error state when attempting to connect for control.
Thanks for any help/advice.
我已经能够get TCP/IP communication established between the Epson and a host PC. This was using the Epson RC control software to configure the TCP/IP communication on the robot controller using USB interface. I then tested communications with ethernet using an offline host PC with the controller configuration which were successful.
When I pass the same parameters to the Epson using the connect online functionality in RoboDK, it tells me that the machine is actively refusing the refusing the connection. [win 10061 error] (I have tested after completely disconnecting from the robot in the Epson RC software first)
I'm not sure which argument could be specified to the robot incorrectly. I have attached a screenshot for your reference. The robot also wasn't in any error state when attempting to connect for control.
Thanks for any help/advice.