RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Not enough valid calibration points
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Not enough valid calibration points

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Not enough valid calibration points
Karl Offline
Member
**
Posts: 46
Threads: 7
加入:2022年7月
Reputation: 0
#16
08-09-2022, 09:06 PM
Solved!!

I checked angles from manually jogging, and A5 was at 90deg when the controller thought it was at 70. I had the incorrect $machine.dat - corrected that based on the nameplate on the arm, and we're good to go. Check out these results!



Thanks for the help earlier Arnold, it made me suspect something was wrong with my physical arm versus the program.
Find
Reply


Messages In This Thread
Not enough valid calibration points - byKarl- 07-28-2022, 05:43 PM
RE: Not enough valid calibration points - byKarl- 07-31-2022, 12:31 AM
RE: Not enough valid calibration points - byKarl- 07-29-2022, 10:17 PM
RE: Not enough valid calibration points - byKarl- 07-31-2022, 04:10 PM
RE: Not enough valid calibration points - byKarl- 08年-01-2022, 09:10 PM
RE: Not enough valid calibration points - byAlbert- 08年-02-2022, 08:07 AM
RE: Not enough valid calibration points - byKarl- 08年-02-2022, 01:04 PM
RE: Not enough valid calibration points - byKarl- 08年-02-2022, 03:45 PM
RE: Not enough valid calibration points - byKarl- 08年-05-2022, 01:55 PM
RE: Not enough valid calibration points - byKarl- 08年-08-2022, 07:09 PM
RE: Not enough valid calibration points - byKarl- 08年-08-2022, 09:05 PM
RE: Not enough valid calibration points - byKarl- 08年-09-2022, 03:32 PM
RE: Not enough valid calibration points - byKarl- 08年-09-2022, 09:06 PM
RE: Not enough valid calibration points - byAlbert- 08年-11-2022, 06:40 AM
RE: Not enough valid calibration points - byKarl- 08年-12-2022, 04:45 PM



Users browsing this thread:
1 Guest(s)