08-02-2022, 08:07 AM
CalibTool 1 is added automatically when you run the Create measurements script.
The laser tracker target was placed at this TCP location:
X=-6.93, Y=-28.67, Z=19.58 mm
Does that make sense?
If so, you can run the calibration procedure. Make sure to not move the laser tracker. The laser tracker should remain in the same location for all measurements.
If you uncheck the option "Follow target", the laser tracker should automatically point to your target.
The laser tracker target was placed at this TCP location:
X=-6.93, Y=-28.67, Z=19.58 mm
Does that make sense?
If so, you can run the calibration procedure. Make sure to not move the laser tracker. The laser tracker should remain in the same location for all measurements.
If you uncheck the option "Follow target", the laser tracker should automatically point to your target.