RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Importing Curves from Solidworks (normal vector probelm)
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Importing Curves from Solidworks (normal vector probelm)

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Importing Curves from Solidworks (normal vector probelm)
zet-jaro Offline
RoboDK专家
***
Posts: 53
Threads: 20
Joined: Dec 2019
Reputation: 0
#3
04-12-2022, 10:25 PM
Hi Alex,

the parameter "Mixed Normal Tolerance" is 0,1mm.

I can check it with another number but I taught that it doesnt matter because my problem is the angle of the vector and not milimeters :) I'll let you know if it made some enhancement.

Kind regards,
Tom
Find
Reply


Messages In This Thread
RE: Importing Curves from Solidworks (normal vector probelm) - byzet-jaro- 04-12-2022, 10:25 PM



Users browsing this thread:
1 Guest(s)