01-25-2022, 02:12 PM
Hi,
I use the Rhino Add-in for RoboDK. I generate curves for a mill to follow (held by a robot).
In Rhino I make a curve that has an offset of half de diameter of the mill w.r.t. the line to mill. Then I use the Add-in to convert the curve to RoboDK and there I create a Curve Follow Project.
When the diameter of the mill would change later in the project, I need to go back to Rhino and make new offset curves, etc.
It would be great to have a tool / utility in RoboDK to give a curve an Offset w.r.t. it's original position.
If some kind of workaround already exists, I would be glad to hear it!
Best regards,
Emile
I use the Rhino Add-in for RoboDK. I generate curves for a mill to follow (held by a robot).
In Rhino I make a curve that has an offset of half de diameter of the mill w.r.t. the line to mill. Then I use the Add-in to convert the curve to RoboDK and there I create a Curve Follow Project.
When the diameter of the mill would change later in the project, I need to go back to Rhino and make new offset curves, etc.
It would be great to have a tool / utility in RoboDK to give a curve an Offset w.r.t. it's original position.
If some kind of workaround already exists, I would be glad to hear it!
Best regards,
Emile