RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Layer Heights from Slic3r are not generating correctly
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Layer Heights from Slic3r are not generating correctly

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Layer Heights from Slic3r are not generating correctly
Albert Offline
Moderator
*****
Posts: 2,314
Threads: 2
Joined: Apr 2018
Reputation: 122
#4
11-05-2021, 01:56 PM
层的高度不能超过你的extruder diameter. I recommend you to increase the size of your extruder before increasing the layer height.

Robot 3D printing usually requires larger values for these 2 variables (compared to desktop 3D printers).
Find
Reply


Messages In This Thread
RE: Layer Heights from Slic3r are not generating correctly - byAlbert- 11-05-2021, 01:56 PM



Users browsing this thread:
1 Guest(s)