08-13-2021, 04:32 PM
Jeremy,
As a stop gap that would work I think to break it up. Long term we have several applications where "what we are trying to do" is the end goal. They are both 5 axis milling and Waterjet cut applications. Unfortunately we are Mitsubishi primary and a Fanuc.
I can also trim down the cutting process. thinking we could stream it, I was a bit lazy in the optimization area.
快速解决方案你有什么想法吗?我们can work the long term issues as we go.
Don
As a stop gap that would work I think to break it up. Long term we have several applications where "what we are trying to do" is the end goal. They are both 5 axis milling and Waterjet cut applications. Unfortunately we are Mitsubishi primary and a Fanuc.
I can also trim down the cutting process. thinking we could stream it, I was a bit lazy in the optimization area.
快速解决方案你有什么想法吗?我们can work the long term issues as we go.
Don