+- RoboDK Forum (//m.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//m.sinclairbody.com/forum/Forum-RoboDK-EN)
+ - - -论坛:通用RoboDK问题(//m.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: Cannot connect to TM12 (/Thread-Cannot-connect-to-TM12)
Cannot connect to TM12-MarcoB2A-06-06-2023
Hi,
I have a TM12 running its TMFlow software and works as expected.
Now I would connect from RoboDK, and Ping to the TM12 IP address is ok.
But the button "Connect" fail with red error "connection problems".
On the robot side the Modbus and Ethernet slave are enabled, but no idea
of what else is necessary to make the Omron accept incoming TCP connection from RoboDK...
Can you help ?
Regards
RE: Cannot connect to TM12-Albert-06-06-2023
你的年代hould connect to the physical port with support for Modbus on the robot controller.
Also, make sure to properly setup the local network with the correct IPs so the computer can reach the robot.
RE: Cannot connect to TM12-Albert-06-07-2023
Also, make sure to follow this procedure to enter in a listen node with the robot:
//m.sinclairbody.com/doc/en/Robots-Omron-TM.html#TM-StartProg