+- RoboDK Forum (//m.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//m.sinclairbody.com/forum/Forum-RoboDK-EN)
+ - - -论坛:通用RoboDK问题(//m.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: RoboDK run on robot Question (/Thread-RoboDK-run-on-robot-Question)
RoboDK run on robot Question-ALEXWANG-11-02-2022
Dear Sir
I can already connect to the TM5-700, but when I run the program, I can only run one point and the connection will be disconnected. How to run the entire program.
RE: RoboDK run on robot Question-Jeremy-11-02-2022
Do you see anything special in the "show log" file?
Or in the robot controller log?
RE: RoboDK run on robot Question-ALEXWANG-11-02-2022
This is my log.
RE: RoboDK run on robot Question-Albert-11-03-2022
做you connect to the correct Ethernet port on your controller?
I believe there is only 1 port that allows controlling the robot.
Are you using a recent version of RoboDK?
RE: RoboDK run on robot Question-ALEXWANG-11-03-2022
I've been able to successfully wire and drive the arm with the RoboDK, but only move one point at a time. If there is more than one point in the program, only one point is active, and the entire program cannot be executed. As long as a point is moved, the connection will be automatically disconnected. How to fix.Thanks
RE: RoboDK run on robot Question-Jeremy-11-08-2022
Can you share the log file of TM Flow?
Jeremy